Mikrotik Configuration Pdf3/11/2021
Also you can go to the device through the web interface and download winbox through the link.Go to the New Terminal menu and with the system reset-configuration command restart the device (after reboot window with settings reset will appear).Then tick No Default Configuration and click on Reset Configuration.
Mikrotik Configuration Download Winbox ThroughTo do this, click button in the Bridge menu (opens a window like in the image below), assign name for the bridge and click OK. On the Bridge line chose our previously created bridge1. ![]() For the standards it is recommended to select only-N value, to raise the maximum speed. If you plan more than 100 Mbit s and using Gigabit device - then you can use a 40MHz bandwidth. You can specify a single frequency, multiple (separated by a comma), the range (with a dash), and can be combined. For example, a value of 2424, 2300-2500 will mean that the first device will start searching for the BS on the channel in 2424, in the absence of a response will go to the range 2300-2500, and will be looking there. If it is exposed in the settings, to the BS will connect only devices that support it. ![]() This setting only works in 802.11 mode for laptops and devices without WDS support. To connect, you must manually register the name of the client device. Noise Floor Threshold - The most common values are set. You can also define it by yourself: to measure the noise level and reduce this figure by 5-10 units. For example: If the sound level -107, therefore, the value we put is -100. Default is 1 minute. Hw. Retries - The amount of data sent repeats unless the acknowledgment of receipt. If you are using the MIMO, it is best to activate both antennas on reception and transmission (chain0, chain1). Of course, if there is only one antenna, then activate one channel. For the base station 5-7 is recommended, for radio bridge - 1-2. Lower the value in this field, smaller the transmission delay is, but the rate decreases. And vice versa - increasing the value will mean more speed, but increased delay. This is a completely separate encryption mechanism unrelated to the fact that we will adjust the Security Profiles tab. If you select Manual, the field with the settings will appear and you can manually adjust radio card power. Standard considered that values from 5 to 15 - low, 15 to 30 average, 30 to 60 - high.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |